Mercer 3 in 1 Crib (6801) - Assembly and Operation Manualrevised 18MAY2011* The Mercer 3 in 1 crib can later be converted into a toddler bed. To conv
AVERTISSEMENT :LIRE TOUTES LES INSTRUCTIONS AVANT L’ASSEMBLAGE DU LIT. GARDER LE MANUEL POUR UNE UTILISATION FUTURE.AVERTISSEMENT : le non-respect des
Rangement: Soin et Nettoyage :L’enregistrement de votre produit est plus facile qu’avant. Vous pouvez enregistrer votre produit sur notre site Interne
page 12Mercer 3 in 1 Crib (6801) - Toddler bed conversion assemblyLit à barreaux Mercer (6801) - Instructions d’assemblage pour la conversion en lit
page 13Le lit doit être utilisé avec un matelas aux dimensions régulières devant mesurer51 5/8" (1310 mm) en longueur, 27 1/4" (690mm) en la
B. Headboard (2)C. Spring frameG. Left post (2)page 2D. Glide support (2)H. Right post (2)M. Drawer backI. Drawer centerL. Drawer frontN. Drawer botto
page 3V. 3/4” Allen head bolt (4)V. Boulon Allen 3/4" (4)T. 1 1/4” Phillipshead screw (12)U. 1/2” Phillipshead screw (10)X.Wood dowel (4) Y. Cam
DDMount glide support (D) on each side panel (A), inserting the wood dowels into the pre-drilled holes. Secure using 1 1/4” Phillips head screws (T).A
WWAttach headboard (B) to the left and right sidepanels using 2 1/4” Allen head bolts (W) and lock washers (VV). Do not overtighten the bolts.page 5At
MSTEP 8.Position the drawer back (M) on the drawer assembly and secure it with wood screws (T). page 6TTTAligner le dos du tiroir (M) a l’assemblage d
page 7STEP 10BSTEP 10ASlide the bearing glide rails out fully as illustration STEP 10A shown. Position the drawer on tabs on the glide rails. Attach
CAUTION: ANY MATTRESS USED IN THIS CRIB MUST BE AT LEAST 27 1/4 INCHES (69CM) BY 51 5/8 INCHES (131CM) WITH A THICKNESS NOT EXCEEDING 6 INCHES (15CM)
WARNING:Failure to follow these warnings and the assembly instructions could result in serious injury or death.READ ALL INSTRUCTIONS BEFORE ASSEMBLING
Kommentare zu diesen Handbüchern